PARTS INCLUDED•PIÈCES INCLUSES• PIEZAS INCLUIDAS part pièce pieza Description description descripción part
Position handle assembly (F) over lower handle tube. Attach using M8x40mm carriage bolts (M), washers (H), and knobs (L) as shown. Disposer l'as
Close bottom clamp (U) and rotate knob into slot in bottom clamp. CAUTION> At least one ladder rung must be captured between clamp and bracket ass
Rotate clamp over ladder. Hold clamp in position and rotate knob handle into slot in bottom clamp. Tighten knob firmly. Tourner le serre-joint par-de
Check ladder stability before lifting. Adjust brackets and clamps as necessary. Vérifier la stabilité d'échelle avant de soulever. Ajuster des c
TIP: If arms are not latching properly, loosen knobs connecting handle tubes to arm, align arms parallel to load bars and retighten knobs. Si les
THULE RACK GUIDELINESC1THULE INC., 42 SILVERMINE RD.SEYMOUR, CT 06483www.thule.com800-238-2388Lorsque vous utilisez les supports et accessoires Thule
THULE will warranty all THULE brand car rack systems and itsaccessories manufactured by THULE during the time that anoriginal retail purchaser owns th
part pièce pieza Description description descripción part number numéro de pièce número de pieza qty. qté cant. N Ladder bracket assembly / Serrer l
3 Remove end cap from one side of load bars. Enlever l'embout protecteur d'un côté de barres de chargement. Quite la tapa final de un lad
FRONT ARM: Insert two square nuts (I) in top slot of arm and slide to opposite end. Insert and slide rubber pad (T) into top slot and slide to center
Position tube holder (E) as shown and attach to square nuts in arm using M6x12mm allen bolt (J). Loosely assemble carriage bolt M8x25mm (G), washer (
Measure distance between ladder rails. Mesurer la distance entre les barres d'échelle. Mida la distancia entre barandas de escalera. For
Apriete utilizando firmemente cerrojos de allen M6x12 (J) y las arandelas (Q). Move rubber pads (T) same distance apart from ladder bracket as ladder
NOTE: Use caution when performing next step. Do not place fingers inside unit. Hold arm in left hand and pull back slightly. Align holes in bar moun
Slide handle tube (C) into tube holders (E). Center handle tube so an equal length protrudes from each holder. Tighten knob to secure. Glisser le tu
Comments to this Manuals